Repair

On this page you will find all the cases that ARE NOT COVERED BY THE WARRANTY due to having misused the device. Warning, to send your unit to the technical service you must make a ORDINARY postal shipment to the following address without name. If you make a certified shipment, it is possible that the package can be returned.

    Apdo 90173
    08021 Barcelona
    Spain

Once the unit is received, the technical service will contact you with an assessment of the repair cost and whether or not it is covered by the guarantee, the shipping costs are the responsibility of the interested party.

Below you will find a list of the most common damages caused by misuse or failure to follow the installation instructions.

Component Description

• A Audio amplifier - LM4952
• B Controllers ICs - MCP23017
• C Audio switch

I have connected the reverse board and now the controls do not work

Integrated circuits B are damaged and must be replaced

I have connected or disconnected the board with the machine turned on and if the audio amplifier has burned, I have no sound

You must change the integrated A

The raspberry does not turn on, none of its LEDs are not even red

This is usually due to a short circuit in the B chips between ground and 5v, you can check it with a multimeter in continuity mode between the pins of the board corresponding to 5v and the pins of the buttons of player 1 and player 2, if any of these does continuity the integrated B must be replaced.

Audio is very low or distorted

Check that the audio switch with which you can select if the output is mono or stereo is in the correct position for your wiring, if your wiring is standard jamma it should be in mono in the position of a single speaker, if your wiring is MVS Should it be in stereo in the two speaker position, prolonged use of the amplifier in the wrong mode could end up damaging the A chip and need to be replaced.